Inside size, outside size and how to measure
Updated 5 November 2026
Every size on this site is an inside size, the space that what you pack sits in. Measure it, add a little room and type the result; the template draws the walls around it.
Measure what goes in
Measure the length, the width and the height at the widest points, with any tissue or wrapping it will have in the box. A jar is as wide as its widest part, often the lid. Round each measurement up to the next millimeter, or the next sixteenth of an inch.
Leave a little room
A box cut to the exact size of what it holds is hard to fill and hard to close. Two or three millimeters a side is a good start for a loose fit. The tool's gift card box shows the idea: a bank card is 85.60 × 53.98 mm, and the box made for it is 92 × 60 mm inside, about 3 mm all round.
What the walls add
The template adds the thickness of the card to every wall, so the inside stays the size you typed and the outside grows instead. On cardstock, counted as 0.25 mm, the outside of a simple box is about half a millimeter wider than the inside in each direction. On 1 mm chipboard it is about 2 mm wider. Set Paper in the tool to what you print on, so the walls are drawn for it.
Lids
A box with lid makes its lid 0.75 mm wider than the base on each side, so it slides on without sticking. Settings changes that from 0 to 3 mm: looser for thick card or a lid you want to lift off easily, tighter for thin paper. The lid covers about 35% of the box's height, never less than 10 mm or more than 40 mm.
When you need a given outside size
For a box that has to fit a shelf, a drawer or a mailer, work back from the outside: take off about half a millimeter for cardstock, or about 2 mm for chipboard, from each outside measurement and type what is left.
When it will not fit on your sheet
If the size is bigger than one sheet holds, the tool says so. What sheet do I need? names the smallest standard sheet that takes it, and Custom sheet size takes any sheet at all, from poster board to a piece of cardboard. Print it at actual size, as the printing guide explains, and measure before you cut.
Make the template
More guides
- How to print a template at actual size: Set Actual size in the print dialog, and measure the scale bar before you cut the card.
- Which cardstock to use for a box: Start with 80 lb cover, which is 216 gsm. A chart of weights from 65 to 130 lb, with each sheet's thickness.
- All guides